1st Choice Snip Tip Applicator Tips Cap for E6000 Craft Glue 3.7 Ounce Adhesive Tubes (4 pc)

Bought these for my shoegoo tubes and they work great thread right on perfect and allow me to have extras to get into those tight spots inside spaces in the shoes. Generally (to save money) I take the one that I just finished using and clean it out when I’m done before the glue drys not perfectly but just to get the bulk out usually using a toothpick to clean out the tip is enough long as u make sure the holes not filled with glue your fine but u can also use a Qtip as well to clean out the inside a bit better if u wish. If you do this each tip will last u quite a while and give you many uses they’re pretty easy to clean and (atleast with the shoegoo) it doesn’t stick to horribly allowing reuse. So I’m satisfied........also these are the same size and type tips that came with my shoegoo when I got it.

Simple to use, and handy to have different tips to make different sizes to use for different application amounts of glue. I don't know why the glue doesn't come with a tip, but very glad I could purchase some separately. No difficulty pushing glue through, and while I could use foil or a pin in the tip to keep the tip on and not allow the glue to dry out, I chose to take the tip off while the glue was still fresh, and stand it up on a discarded plastic butter tub lid and allow the glue to drip to the bottom, then used a toothpick to use the expelled glue on a few cabochons I was applying to a mason jar. Once more set up, I was able to use a tweezer to remove the glue from the tip making it fully usable again.

These were fine, they were recommended for the E6000 glue and they definitely don't fit lol my fault is for not actually checking but I fell for what Amazon recommended

I put this tip on my glue tube and the entire back of the tube blew out. I cut the tip almost half way down to allow enough of an opening and after squeezing it for a while I decided to cut it more. The hole was now too big; however I still wanted to see if it would come out. It did... just out the back of the glue tube. So not only did I waste money on these tips, but my entire glue is now compromised and hard because the bottom blew open. Pretty peeved.

I bought these tops so I would have extra ones if needed because I love the E6000 glue. I love it a lot more then using a glue gun I am always burning my fingers and these tops help to squeeze the glue out at whatever size that you need it to come out too cuz you can cut them to a small hole or bigger hole to get the glue out that's why I like to order more tops so I can have different size holes. It doesn't take long for the glue to dry and you can use it on just about anything. No more burnt fingers.

Too big for e6000

I had these on hand to use as directed and was surprised that there were no caps to reseal the tip after it’s snipped open. I came back to the page to make sure and only then saw other complaints about the same thing. What were the people who sell these thinking selling them that way? As soon as I use these up, I’ll buy some that have caps like the huge majority of products with pointed applicator tips do.

Ok