XSPC Single 5mm RGB LED (4-pin)

As other reviewers indicated the colors are way off on the LEDs. Red is the pre-dominant color with blues and greens cycled through too quickly.I needed these RGBs to match my external LED strips, and instead those colors look like they are being run on a different controller. I will be returning these.Build quality is decent but the LED end is very stiff for over 2 inches at the end. Not sure how much you can bend this out of the way, if needed.

Nice touch to the standard single color led that comes with the Photon. Plus, its actually working off my Asus RGB header so I can use Aura to control it.

Item arrived in perfect condition. This LED will light an xspc waterblock intended for a 1st gen Titan 6GB card. This LED IS intended for an all green build so hopefully this will accommodate.

Green and blue cuts out on color cycle faster than it normally should, so red is a very dominant color with this led... it will have difficulty displaying yellow, orange, magenta and pink... but if you tweek it just right they will display...

Works perfectly with Gigabyte z390 aorus pro rgb fusion.

low quality make, cable was broken, returned and resold to me with a garbage solder repair

Awful color calibration. The only way this led was not full red was with colors that have 0 red in the mix. All other leds in my rig no problem. I ended up opening the wires and cutting the red one, at least now it does proper combinations of blue and green.

I have an Asus Prime z390 motherboard. I 3d printed a little penguin to keep my Graphics card from sagging. I put this little rgb light in the penguin and connected it to one of the RGB headers on the motherboard, from there I could sync it with Aura, no problem!