LIQUI MOLY Exhaust Assembly Paste | 150 g | Paste | SKU: 3342, farblos, blue

Fitted a silencer removal recently and needed some exhaust paste for the new straight through.This paste is fantastic - if a little messy.It’s more liquid initially so make sure you shake the bottle to get the mix going.I personally prefer the more spreadable nature of this paste compared to some others I’ve tried as it’s easier to apply and gauge the amount you need!You could use a spatula I guess but I just put on some rubber gloves, spread the paste on the join to create a nice amount then placed my new pipe on. Used the excess to seal any gaps, then bam it starts to harden.Before a drive simply start the car let it heat up to ‘set’ the paste and you’re gold!

Other reviews have said this was too watery but I found it easy to apply and it created a good seal as soon as the exhaust was up to temperature.

I used this to repair a snapped exhaust that needed sealing around the new sleeve. Once dried it has prevented any exhaust gases from leaking from the new section. If like me you are repairing a large section I would advise against running the engine to speed up the drying process as this just blew all my putty over my driveway. Removed a star from the rating as the consistency of the putty is very watery initially.

The stuff did what it should very effectively, dried quick.

Best product I've purchased for sealing my exhaust pipe joints, highly recommended. Far better than holts paste

When I opened the tube and squeezed some of the paste out it was just watery paste 😕. I had to keep squeezing the tube before I got the thick stuff so I didn’t get a full tube of paste.

Great product! Worked great. Fitted full exhaust system and one tube was the exact amount I needed. Will order again.

Having tried several other well known brands ( with variable success ) I decided to try this out ( as I have other products from their range ). Application was straightforward, applied to exhaust pipe and outlet port on cylinder head of classic motorcycle and push fit together. Ran engine for a few minutes ( low revs) and product dried to produce an airtight ( exhaust -tight ) joint. Please note… you must manipulate the product with your fingers by massaging the container tube ( thereby mixing it ) for a minute or two. If you do not the product will emerge either very thick or very thin ( almost a liquid ).I can recommend this product, not the cheapest but ……..? You gets what you pay for!