VViViD 3M Clear Paint Protection Vinyl Film 12" Wide Choose Your Size Including Tools (12" x 6")

This film was really easy to apply with a spray bottle of water and a good quality flexible squeegee (make sure to use distilled or reverse osmosis water to avoid hard water residue). The material was easy to conform to the compound curve of my motorcycle gas tank. Also there was enough stretch that I could peel up and reposition the sheet easily. It looks much more discreet than an adhesive tank pad, almost impossible to see the film except in direct sunlight. The edges have not peeled up in hot weather or when washing the bike. A little expensive for the amount of material, but it’s worth it for the quality product. For the front of the whole bike or a car, probably more economical to go to a shop. But definitely recommended for discreet protection of relatively small areas like the back part of the tank or the side panels you always hit with your boot. Probably very useful for scratch protection around the house too. Recommended.

Installed on RAV4 headlights with zero experience. No bubbles or peeling off so far.

I'm sure it's a fine product and works well with a proper installation, but I had no luck getting this to work right on my headlights. If you don't have the patience for doing things that are tedious and frustrating, this is not for you and I recommend having a professional install it. It would be easy to placed on lights that are mostly flat and rectangular, but modem car headlights with more complex shapes are significantly more challenging to wrap without getting several wrinkles and air pockets. My headlights have a sharp crease line in them that made it almost impossible to stretch over. Even with heat applied and numerous reapplications with wet film, it simply would not adhere smoothly and I had to give up. My headlights are also very large and took 99% of the roll to completely cover and even then the width is only barely wide enough for them - this leaves NO room for mistakes. And mistakes are easy when you're working with a giant curled up rectangle of adhesive vinyl... this stuff wants to curl and stick to itself constantly and it's hard to peel apart again. If you're working with huge pieces like I had to, I almost recommend having a second person to hold the other end of the sheet for you so it can stretch from all 4 corners. That might make applying it easier too. I don't want to knock the product itself too much because I can tell it's high quality vinyl. The parts that did stick properly were nice and clear and it was easy to squeegee out the moisture. I recommend buying a softer silicone or rubber squeegee though, as the provided plastic one seems really sharp. Overall, this is not a simple product to install if you have complex headlights. It takes a ton of patience, some handy skills, and extreme delicacy to do it right. I'm not really sure it's worth the frustration for a few years of protection that a good spray-on clear coat might be able to compete with.

Easy to apply on ebike to protect paint from panniers. Applied on seat stay. I was worried about applying on the rounded edges or rectangular seat stays. Not to worry went on nicely and its very hard to tell anything is applied.

Update (5/30/25) — It is now almost 3 years later and this stuff is still holding up strong! No peeling either! (Prep and install are key though, so your results may vary if you do not install it properly!). This has had full UV exposure the whole time, never garaged and has seen all seasons. This is definitely worth it, I would still recommend the product to this day! Lastly I have changed the title from its original “It’s good ppf” to “It’s great ppf” as it has exceeded my expectations!Original (8/13/22) — If you know how to install this stuff it works great, if you don’t you’ll probably hate it. It worked great to protect my door sills on my 22 wrangler and holds strong. Would buy again!

Did not receive squeegee and other two items.

good item for the price..good for edges were you want to protect against dirt or scratches..

I actually used this on my car’s interior center console, where I’m worried the center console might get scratched.First: For the price, I don’t think this is enough material; It’s only 12”x12” and doesn’t cover much. Second: it is difficult to apply without any bubbles or visible imperfections under it. I cleaned the surface thoroughly before applying the film and made sure there was no dust or debris under it. Maybe this is not the intended application - maybe it would go on better if it was covering the exterior paint or something, so take this comment with a grain of salt.